E02014/ Cutter Unit Fuse Failure Error; E02015/ Cutter Error; E02400/ E02401/ E02402/ E02403/ Path Mismatch Error; E02405/ E02406/ E02407/ Borderless Printing Error - Canon WS8400 Service Manual

6.1.4.5 E02014/ Cutter unit fuse failure error

Blown cutter unit fuse
<Cause>
The fuse in an option cutter unit PCB is broken.
<Probable problem locations>
Option cutter unit PCB
<Remedy>
1. Replace the option cutter unit.

6.1.4.6 E02015/ Cutter error

<Cause>
This is displayed when the registration sensor could not detect the media leading edge during detection after cutting of the roll media.
<Probable problem locations>
Media, registration sensor, cutter unit, engine controller and system controller
<Remedy>
1. Media check
Replace any media that have printing or soilling at the detection position or that are outside the prescribed.
2. Registration sensor error
If the errors E0200A, E0200B, E0200C, E0200E, E0200F, E02010, E02017, or E02018 are displayed during a printer operation other than media cutting,
see Registration sensor error.
3. Visual check
Remove any foreign matter and resolve any other problems affecting the cutter unit.
Replace cutter unit if it is damaged, deformed or otherwise malfunctioning.
4. Replace the engine controller
5. Replace the system controller

6.1.4.7 E02400/ E02401/ E02402/ E02403/ Path mismatch error

<Cause>
This is displayed when the loaded media is a cut sheet when the received data is designated for roll media.
This is displayed when the roll media is not loaded when the received data is designated for roll media.
This is displayed when the cut sheet is not loaded when the received data is designated for cut sheet.
This is displayed if the loaded media is roll media when the received data is designated for cut sheet.
This is displayed when printing the adjustment pattern if the loaded media is smaller than the prescribed size of the adjustment pattern.
<Probable problem locations>
Media, engine controller, system controller
<Remedy>
1. Media check
Check the media loading status, and reload the media if the media are different from the transmit data, the media are not loaded, or the loaded media are
outside of the prescribed size.
2. Replace the engine controller.
3. Replace the system controller.

6.1.4.8 E02405/ E02406/ E02407/ Borderless printing error

<Cause>
Current media loading position is unsuitable for Borderless Printing.
Data not compatible with borderless printing was received.
Media with width not allowed for borderless printing is set.
<Probable problem locations>
Printer operating procedure error.
<Remedy>
1. Check correct operating procedure and retry print operation.

6.1.4.9 E02500/ E02501/ E02502/ E02503/ E02504/ E02505/ Ink empty error

<Cause>
This is displayed when no ink is detected in the ink tank.
<Probable problem locations>
Ink tank, engine controller, system controller
<Remedy>
1. Replace the ink tank.
2. Replace the engine controller.
3. Replace the system controller.

6.1.4.10 E02506/ E02507/ E02508/ E02509/ E0250A/ E0250B/ Ink tank uninstalled error (during ink tank replacement)

<Cause>
Chapter 6
0009-9998
0009-7092
0009-7094
0009-7096
0009-7097
0009-7099
6-7