Check" And"Batiey; Power Faiiure; Other Dispiays (Fixed Word Consoles) - ADEMCO via30 Installation Instructions Manual

TROUBLE CONDITIONS
General Information
"Check" and
"Battery" Dispiays
Power Faiiure
Other Dispiays
{Fixed Word Consoies)
The word "CHECK on the Console's display, accompanied by a rapid "beeping"
at the Console, indicates that there is a trouble condition in the system. The au-
dible warning sound can be silenced by pressing any key. Instruct users to call for
service immediately upon seeing any of the following messages.
Q A dlspiay of "CHECK" and one or more zone numbers indicates that
a problem exists with the displayed zone(s) and requires attention.
When the problem has been corrected, the display can be cleared by entering
the OFF sequence (code plus OFF key) twice.
c if there are wireless sensors in the system, the CHECK condition may
also be caused by some change in the environment that prevents the receiver
from hearing a particular sensor.
A dispiay of "BAT'" with no zone number indicates that the system's
main standby battery is weak.
A display of "BAT" with a zone number and a once per minute
"beeping" at the consoie indicates that a low battery condition exists in
the wireless sensor displayed (zone "00" indicates a wireless keypad). If the
battery is not replaced within 30 days, a CHECK display may occur.
Not e: Some wireless sensors contain a non-replaceable long-life battery
which requires replacement of the entire unit at the end of battery life
(e.g., Nos. 5802, 5802CP, 5803).
If there is no console display at all, and the POWER indicator (if
present) is not lit, operating power for the system has stopped and the sys-
tem is inoperative.
if the message "AC LOSS" or "NO AC" is displayed, and the
POWER Indicator (if present) Is off, the console is operating on battery
power only.
di
If this remains displayed for more than 1 minute, the system is disabled.
CC The system is in communication with the central station for change of func-
tion or status verification.
*
F C A communication failure has occurred.
O C The console is not receiving signals from the control panel and sees an
open circuit.
–20–