Drive Configuration; Configuring Ip Address Of Cu - Siemens SINAMICS G120 Manual

5 Drive Configuration

Drive Configuration
5
Commissioning of the G120 drives is not in the scope of this document. Refer to
the "Getting Started Manual" for your G120 model to assist in the commissioning of
the drive(s). See the link below for G120 Getting Started manuals.
https://support.industry.siemens.com
5.1

Configuring IP Address of CU

The IP address can be set from Starter. Make sure that your PC is in the same
Subnet as address desired for the G120 and AB PLC.
Figure 5-1 TCP/IPv4 Address for PC or PG
Figure 5-2 Use Accessible Nodes to Find CU250. Right click on Node to Open address
SINAMICS G: Control of a G120 with an Allen-Bradley controller
(Compact/ ControlLogix with RSLogix 5000) via EtherNet/IP
Entry-ID: 82843076, V4.0,
setting.
09/2018
19