Siemens SINAMICS G120 Manual page 34

8 Drive Parameter Access
Attribute:
This is the parameter index. For
parameters without an index, use "0".
Destination:
For reading a parameter select a
Controller scope tag where the
value will be written.
If writing a value to the parameter,
select a tag in the Source element
entry.
Source Length (writing only): When
writing to a parameter, make sure
the source length matches the
parameter that you are trying to
write to.
INT = 2 Bytes (16 bit)
REAL = 4 Bytes (32 bit)
SINAMICS G: Control of a G120 with an Allen-Bradley controller
(Compact/ ControlLogix with RSLogix 5000) via EtherNet/IP
Entry-ID: 82843076, V4.0, 09/2018
34