New Leader L4000G4 Manual page 62

Header
Initial Startup
3. Figure 3A - 3B - Check Spinner Assembly
squareness by measuring from top edge of
left hand Sill to inner hex fl at on right hand
Spinner Hub bolt. Repeat for opposite side.
4. Measurements must be equal, or no greater
than 1/8" off overall.
5. Figure 4 - If adjustments are necessary,
loosen the four 1/2" carriage bolts and adjust
assembly as necessary. Once corrected,
tighten hardware to recommended torque.
See "Standard Torques" for details.
307074-AA-I
62
L4000G4
Figure 3A
Figure 3B
Figure 4
www.New-Leader.com
(800) 363-1771