New Leader L4000G4 Manual page 51

Introduction
Header
Stake: Side support for main hopper walls.
Rear Endgate: Welded or bolt-in endgate (depending on model) furthest from chassis cab (Rear based
on direction of travel). Holds mounted Feedgate, allowing for rear release of material from bin.
Bin 1: Main holding bin for material or Insert. MultApplier and MultiBin inserts (shown on following
pages) are confi gured as Bins 2-4 depending on type used.
Feedgate: Adjustable gate mounted into Rear Endgate. Allows for variable rates of material fl ow by
adjusting jack to desired height.
Conveyor: Conveys material to rear of unit.
Inverted "V": Mounted inside Main Hopper when Insert not installed. Distributes weight pressure
across conveyor, allowing for consistent material fl ow to Feedgate, and promotes an improved blend
when spreading fertilizer.
Material Divider: Ensures uniform spread pattern by directing material off of conveyor onto spinner discs.
Hillside Flow Divider: Ensures balanced fl ow of material across conveyor when on hillsides or uneven
terrain.
Sill: Base of Main Hopper side walls. Contains Conveyor and supports machine walls.
Cross Tubes: Supports body, attaches to Chassis frame. Transfers weight from Main Hopper to Chassis.
Spinner Assembly: Contains adjustable G4 Spreader system, consisting of hydraulic spinners used
for dispersal of various materials at different positioned settings allowing for consistent, even spread
patterns across a wide variety of materials with a high rate of accuracy.
Spinner Guards: Upper and Lower guards, protects operators from spinner discs. Must be in place
during any operation.
Spinner Defl ectors: Defl ect material away from machine.
Lift Hooks: Used to lift unit or insert with appropriately rated lifting device.
www.New-Leader.com
(800) 363-1771
51
L4000G4
307074-AA-I