Ericsson BUSINESSPHONE 250 System Administrator Manual page 10

START SYSTEM PROGRAMMING
START SYSTEM
PROGRAMMING
(continued)
Enter
Enter
8
Enter the relevant command group
Available command groups are 01 to 91. See chapter
"Command groups and numbers".
Press (pre-programmed)
Enter the relevant command number
Available command numbers depend on the entered com-
mand group, see chapter "Command groups and numbers".
Press (pre-programmed)
Tip! The command group and number can be entered in one
sequence, e.g. 0201 to allocate number of programmable keys.
Enter the relevant values
The value could for instance be a facility number, extension
number, trunk number, command number or directory
number. See the example below.
Confirm the relevant value with "YES" or "NO"
How to write text, see section "Write text".
Tip! When "YES" or "NO" is to be entered it is enough to just
enter the first letter, i.e "Y" or "N".
Press to finish programming
Tip! To speed up your programming procedures, see chapter
"Navigation and editing during programming".
BusinessPhone 250 - System Administrator´s Guide
BusinessPhone 50 - System Administrator´s Guide