Table of Contents
Advertisement
Quick Links
CAT
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The most recent versions of this guide and the
installation manual are available at the "Downloads" section on Erreka's website.
http://www.erreka-automation.com
WARNING
The options and functions described in this guide apply for the firmware version indicated on the circuit. The
firmware, as part of a process of continuous improvement, is subject to new functionalities or upgrades being
included as a result of new versions which are not necessarily compatible with previous ones. For this reason,
some options or functions may differ or be unavailable if your firmware is older than shown in this guide.
Assembly levels (mm)
90
135
200,5
Elements of the complete installation
200
FCC
130
FCA
E287C
Manual operation
º
9 0
Unlocking for manual operation:
• Insert the key (1) and turn clockwise about 90º, without
forcing it.
• Pull the release lever (2) until it is about 90º, without forcing it.
Motorised operation locking:
• Proceed in reverse order to release.
• Move the gate manually to interlock it in the operator
mechanism.
English
Electrical wiring
A: Main power supply
B: Flashing light
C: Photocells (Tx / Rx)
D: Pushbutton/wall key
E287D
º
9 0
D287A
5
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Erreka CAT
Summary of Contents for Erreka CAT
-
Page 1: Manual Operation
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and other explanations which must be taken into account. The most recent versions of this guide and the installation manual are available at the "Downloads" section on Erreka's website. http://www.erreka-automation.com WARNING The options and functions described in this guide apply for the firmware version indicated on the circuit. - Page 2 General connections Ensure the power supply is disconnected • The panel has a built-in radio receiver (RSD) to before making or changing the connection. receive transmitter signals at 433.92MHz. When the connections are complete, return the control panel cover. SPEED HALL LOOP...
- Page 3 Turning direction check Turning direction: check operation using the OPEN and CLOSE connectors. If turning direction is not correct, interchange the motor cables connected to cable connectors MOT1 and MOT2. Total opening radio code programming Connect the electrical power Press the transmitter button to be supply.
- Page 4 Function and mode selection using SW1 E287L Modes and functions Option Effect no soft-startup DIP1 Soft start-up with soft-startup. Limit Switches normally closed DIP2 Limit Switches Limit Switches normally open step-by-step mode (the gate only closes when receiving DIP3=OFF and DIP4=OFF the key command) 12s automatic mode (the gate closes automatically after DIP3...
Need help?
Do you have a question about the CAT and is the answer not in the manual?
Questions and answers