Digital Inputs; Digital Outputs - ABB UMC22-FBP Technical Description

Universal Motor Controller UMC22-FBP
Software version 4.0
Chapter 5.3~1 and 5.4~1

5.3 Digital inputs

Number of digital inputs
Supply for digital inputs (terminal 12)
Supply output current for inputs (terminal 12)
Voltage when standard contacts are used
Isolation
Input signal bounce suppression
Signal 0 range including ripple
Signal 1 range including ripple
Input current per channel (24 V DC)
Input resistor to 0 V
Cable length

5.4 Digital outputs

Number of digital outputs
Type of digital outputs
Grouping of contacts
Voltage range of contacts
Lowest switched power for correct signals
Switching capacity
per relay contact
acc. to EN 60947-5-1
Total current all contacts (terminal 5 or 6)
Short circuit protection
Switching of inductive power
Relay contact lifetime
Internal clearance and creepage distances
relay contacts to 24 V circuits
UMC22-FBP
unshielded
shielded
AC-15 240 V AC max. 1,5 A
AC-15 120 V AC max. 3 A
DC-13 250 V DC max. 0,11 A (electromagnetic load)
DC-13 125 V DC max. 0,22 A (electromagnetic load)
DC-13 24 V DC max. 1 A
mechanical
electrical 0.5 A
(250 V AC)
1.5 A
with ABB
contactors
- 72 -
6 (DI0 ... DI5)
Internal or external
see chapter 3.2.1
max. 200 mA
min.18 V
no
see chapter 3.2.1
typ. 4ms
-31.2...+5 V
+13...+31.2 V
typ. 6.0 mA
3.9 k
max. 600 m
max. 1000 m
3 (DO0 ... DO2)
relay contacts
3 contacts with 1 common
12-250 V AC/DC
1 W or 1 VA
(electromagnetic load)
(electromagnetic load)
(electromagnetic load)
max. 4 A (thermal limit)
6 A gL / gG
Inductive loads need additional mea-
sures for spark suppression. Diodes for
DC voltage and varistors / RC elements
for AC voltage are suitable.
Some DC coil contactors contain rec-
tifi ers which suppress sparks perfectly.
500 000 switching cycles
100 000 switching cycles
50 000 switching cycles
see chapter 3.2.2
> 5.5 mm
(safety insulation up to 250 VAC)
(EN 60947-1, Pollution degree 2)
FieldBusPlug / Issue: 02.2008
V 6