Table of Contents
Advertisement
MAINTENANCE
17 17
17 17
17
Maintenance Schedule
1 7 1 7 1 7 1 7 1 7. 2 . 2 . 2 . 2 . 2
Maintenance Operation
Engine (See Engine Manual)
Check for excessive vibration
Clean Debris Bag
Check bag strap tightness
Inspect for loose parts
Inspect for worn or damaged parts
Lubricate Chains and Clutch
Inspect Chains and Clutch
MAINTENANCE HISTORY
Date of Service
Part No. 890257
continued
Follow these hourly
maintenance intervals.
Every
Every 5 hrs
Every 10
Every 25
Use
or (Daily)
hrs
hrs
Service Performed
Page 9 of 12
DRIVE
1 7 . 3
1 7 . 3
1 7 . 3
1 7 . 3
1 7 . 3
Chains are normal replaceable wear items. A new chain
should not be used on worn sprockets. Sprockets should be
replaced when replacing chains.
Stop engine and disconnect spark plug
wire before making adjustments.
CHAIN ADJUSTMENTS
1. Remove chainguard (item 118) and 3 screws
2. Inspect chains (items 87 & 88), for wear, (see chain replace-
ment), lubrication and correct adjustment.
3. If adjustments are required, loosen 4 carriage bolts (item
90), that hold bearing brackets for jackshaft assembly.
4. Adjusting all (3) chains at same time is necessary and can
be done by pulling jackshaft (item 93), up and forward.
5. Tension chains - similar to bicycle chain tightness with
about 1/8" (3.2mm) deflection with light hand pressure mid-
way between sprockets. A slightly loose chain is better than an
over tightened chain. DO NOT over tighten.
6. With chains aligned and tensioned, and jackshaft (item 93),
square and level, tighten carriage bolts (item 90).
7. Completely rotate drive wheels around several times to
insure there are no excessively tight areas in the chain.
8. Repeat steps 4 thru 7 if chains need readjustment.
9. Reinstall chainguard (item 118).
CHAIN REPLACEMENT
1.
With chain guard removed, loosen carriage bolts (item 90),
that hold jackshaft (item 93), and bearing plates (item 101).
2.
To replace inner chain (item 88), remove jackshaft
assembly and install replacement chain.
3.
To replace wheel chains (item 87), slide bearing plates
(item 101), toward engine to loosen chains. Remove front
wheels. Reinstall replacement chains with wheels and onto
jackshaft sprockets.
4.
See steps 4 thru 7 for chain alignment and adjustment.
5.
Reinstall chainguard (item 118).
CLUTCH ADJUSTMENT
The clutch control cable is pre-adjusted at the factory, so when
the bail is released, rod (item 115), engages clutch assembly
(item 121), to stop forward drive motion and allow forward and
backward free-wheeling. When the bail is held against handle,
the clutch rod moves away from clutch assembly to allow drive
engagement.
If drive will not disengage, adjust and align control bracket so
that rod (item 115) fully contacts triangular plate on clutch
assembly when bail is released (see fig. 8).
See lubrication intervals on Maintenance Schedule.
Triangular
Control
115
Rod
Plate
Bracket
(item 81 & 71)
Clutch
121
Form No. F021695H
.
Advertisement
Table of Contents
