Midland SP-8 Operation, Parts And Service Manual page 39

Push in moveable section of hydraulic extension
17.
till the sleeve of hydraulic cylinder rod (R) is in-line
with the mounting brackets.
Insert hinge pin (Q) through the in-line holes and
18.
insert cotter pin (P) to secure it
Mount right side outer edger assembly (L) to
19.
outermost blade section on right side blade
assembly using hardware (K). Tighten cap screws
to 60 lb/ft of torque.
   
Repeat steps 6 to 16 in section 5.7.2 to tuck outer
20.
edger assembly to blade assembly and constraint
blade assembly to machine.
Toggle conveyor direction switch on operator
21.
console to left side.
On left side set up blade assembly position as in
22.
section 5.3.1.
Lower blade assembly to ground by toggling grade
23.
switch.
Switch engine off.
24.
Close and lock control panel cover.
25.
www.roadwidener.com
   
Remove left side outer edger assembly (W) from
26.
outermost blade section. Use suitable lifting device
to separate outer edger assembly.
Use suitable lifting device to lift hydraulic extension
27.
(N) and bolt its fixed section to outermost blade
section on left side with the help of mounting
hardware (M). Tighten cap screws to 60 lb/ft torque.
Note: In this scenario, bottom edges of hydraulic
extension on right side become top edges on left side.
Bolt left side outer edger assembly (W) to moveable
28.
section of hydraulic extension with mounting
hardware (K). Tighten cap screws to 60 lb/ft of
torque.
Insert ends of outer edger brace (H) into turnbuckle
29.
mounts (J) and (T). Insert cotter pins (G) to secure
outer edger brace. Rotate turnbuckle to make
outer edger parallel to inner edger.
If slope tube is required to be installed on fixed
30.
section of hydraulic extension, use mounting hole
(X)
   
   
   
   
Model SP-8 & 10
   
   
33