Oller 5.5 Set Hopper Gates; Istance S Etup - Midland SP-8 Operation, Parts And Service Manual

Model SP-8 &10
5.4.3 H p
ydrAulIC usH
Start machine as in section 5.2.
1.
Have dump truck back up towards hopper until truck
2.
tailgate position is such that with tailgate locked
material should dump in center of the hopper ,
not on road or back of hopper. There should be a
minimum of 6 inch clearance above belt for tailgate.
Toggle push roller switch (A) to move push roller
3.
beam forward until push rollers touch rear tires of
dump truck.
5.5 s H G
et opper
^
Prevent serious injury or death.
Before performing inspections, service or
maintenance:
Park machine on firm, level surface and
•
engage parking brake.
Switch engine off.
•
Close and lock control panel cover.
•
Chock tires.
•
Procedure illustrated here is for dual sided machine
with optional end gate assemblies to control material
flow at discharge end. Instructions are same for single
sided machine with one end gate assembly.
Park machine on a firm level surface, engage
1.
parking brake by pushing E-stop button operator
console fully down.
Switch engine off
2.
26
r d s
oller IstAnCe etup
Ates
WARNING
Close and lock control panel cover.
3.
Turn crank (A) clockwise on desired side of hopper
4.
to lift gate (B) as high as required for sufficient
material flow.
On opposite end gate assembly in hopper, turn
5.
crank (C) counterclockwise to lower gate (D).
Lower gate (D) until the gap between rubber seal
6.
(E) and conveyor belt (F) is approximately 1/4 inch.
www.roadwidener.com