Midland SP-8 Operation, Parts And Service Manual page 38

Model SP-8 &10
Dismount hoses from blade sections by unbolting
9.
hose clamps from welded studs (F).
Remove cotter pins (G) to disengage outer edger
10.
brace (H) from turnbuckle mounts (J).
Remove mounting hardware (K) to dismount right
11.
side outer edger assembly (L) from moveable
section of hydraulic extension.
Remove mounting hardware (M) to dismount
12.
hydraulic extension (N) from right side blade
assembly.
Remove cotter pin (P) to remove hinge pin (Q). This
13.
will disengage the rod end of hydraulic cylinder (R)
from moveable section of hydraulic extension (N).
32
Pull the moveable section (S) of hydraulic extension
14.
out till mounting hardware (U) for turnbuckle mount
(T) are visible.
Note: Do not remove the moveable section of hydraulic
extension completely from the fixed section. Guide
tubes will spring out. It will be difficult to align them with
outer tubes on fixed section during re-assembly.
Remove mounting hardware (U) to dismount
15.
turnbuckle mount (T).
Re-install turnbuckle mount (T) in mirrored position
16.
on bottom two holes on moveable section using
mounting hardware (U). Flat head side of bolt (V)
must be towards convex side of the curved part
and flush with outer surface.
www.roadwidener.com