Midland SP-8 Operation, Parts And Service Manual page 35

On left side of hopper, turn crank (E) clockwise
6.
to lift gate (F) up as high as required for sufficient
material flow.
Use a suitable lifting device to lift operator console
7.
assembly (G) from right side console mount socket
to install into console mount socket (H) on left side.
Remove pin (I) to lift seat assembly (J) from right
8.
side mounting socket and insert into left side
mounting socket (K).
www.roadwidener.com
To adjust seat height, line up appropriate hole in
9.
seat post with hole in mounting socket and insert
pin (I).
5.7.2 B s C
lAde Ide HAnGeover
^
Prevent serious injury or death.
Before performing inspections, service or
maintenance:
Park machine on firm, level surface and
•
engage parking brake.
Switch engine off.
•
Close and lock control panel cover.
•
Chock tires.
•
Start machine as in section 5.2. If machine is in
1.
motion, park machine on a firm level surface,
engage parking brake by pushing operator console
E-stop button fully down. Keep engine running.
Toggle conveyor direction switch on operator
2.
console to right side.
Lower blade down to ground by toggling grade
3.
switch on operator console.
Switch engine off.
4.
Close and lock control panel cover.
5.
Remove pin (A) and remove push tube (B) from
6.
ball hitches on machine.
Model SP-8 & 10
WARNING
29