Unicum Foodbox Series User Manual page 35

ТМ
Adjustment of the spiral end position
For a stable product support and a reliable dispense the correct adjustment
of the spiral end position is very important.
The spiral end position is set properly when the product is safely held and is
pushed out from the spiral end.
Turn the spiral counter clockwise, for the control of sales according to product.
Replacing single cells with double cells
1. Remove the four shelf barriers in the direction shown by arrows in fig. 6.6.
2. Disconnect the motor connectors (fig. 6.7) and remove all motors with
spirals.
3. Remove any four spirals from the holders (see above).
4. Install the spirals on the motor holders (see above), moreover, use two
spirals with different spooling directions but with an identical spooling pitch.
5. Install the motors on the shelf and restore the connections.
4
3
1
figure 6.6 - Shelf with single cells
Note: When using high products the use of high barriers is recommended.
Version 1.0 / 11-2018
2
figure 6.7 - Motor connector
disconnection
35