Unicum Foodbox Series User Manual page 34

ТМ
Changing spirals
Disconnect the electric motor power connectors (fig. 8.3, pos. 1) and pull
out the shelf.
AttENtIoN!
to avoid vending machine overturning don't pull out all shelves
simultaneously!
If the factory installed spiral is not adequate for selling products, you can
select a spiral, corresponding with the product dimensions, and replace the
factory installed spiral.
Turn the spiral with left spooling counter-clockwise (in the case of right spool-
ing - clockwise) until the spiral end clicking position and remove the spiral from
the holder (fig. 6.4).
Install the required spiral on the holder (fig. 6.5) and turn it until the spiral
end clicking position.
After the spiral replacement put the shelf in place and connect the motors.
Version 1.0 / 11-2018
1
figure 6.3
figure 6.4
1
2
figure 6.5
34