Install The Module - Allen-Bradley E Series Installation Instructions Manual

Install the Module

Slide the module into
the chassis. Make
sure the module
backplane connector
properly connects to
the chassis
backplane
The module is properly installed when it is flush with the power
supply or other installed modules.
Do not force the module into the backplane connector. If you cannot
ATTENTION
seat the module with firm pressure, check the alignment. Forcing the
module into the chassis can damage the backplane connector or the
module.
ControlLogix ControlNet Interface Module 15
Publication
1756-IN604A-EN-P - February 2006
Align the circuit board with
top and bottom guides in
the chassis.
Circuit
Board