Chapter 6 Operation; Preparing The Incubator; Starting Operation - Fisher Scientific Isotemp Series User Manual

Operation

Preparing the Incubator

The incubator must not be released for operation before all major start-up activities have been
completed (see
Device Check
Prior to starting operation, the following incubator components must be checked for their
correct function:
• The door seal in the front frame must not be damaged.
• The glass door must not be damaged.
• The shelving components must be installed safely.
• Disinfecting the Incubator's Work Space
Disinfect the work space according to the operator-specified hygiene guidelines.

Starting Operation

1. Turn the incubator on using the control panel.
2. Adjust the temperature set value on the control panel.
3. The temperature controller starts adjusting the work space to the user-specified
temperature set value now.
4. Load the work space with samples.
Fisher Scientific
chapter 5, "Start-up." ).
• refrain from loading the incubator with any of the substances
listed in the section
• make sure that the ambient air is free of any solvents
• do not operate the incubator in areas with an explosion hazard
To avoid any risk of explosion or fire
"Incorrect Use" on page 1-5
Gravity Convection Incubators
6
6-1