Installing The Anti-Tilt Anchor - Fisher Scientific Isotemp Series User Manual

Installing the Anti-tilt Anchor

Table-top incubators
The anti-tilt anchor secures the device to a solid part of a building. The anti-tilt anchor is to
be mounted on the side opposite of the door hinges.
Bend the fixing tabs of the anti-tilt anchor up on one side and down on the other by an angle
of approx. 90°.
1. Do not use this position if the door is hinged on this side. Right-hand hinges represent the
standard configuration.
2. Preferred position.
3. Alternative position. Do not use if the door is hinged on this side.
Remove the bracket screws. Use the preferred position, if possible.
Fix the anti-tilt anchor with the bracket side down to the unit.
Position the unit with the anti-tilt anchor to in an angle of approx. 90° +/- 20%.
Take care that the stacking feet of the unit are still in correct place on the lower unit or on the
stacking adapter.
Fix the anti-tilt anchor to a solid part of the building.
Floor stand incubators
Fisher Scientific floor stand incubators must always be attached to the wall
using two (2) retaining brackets on the outer left and right side on the back of
the unit.
Fisher Scientific
Installing the Anti-tilt Anchor
Gravity Convection Incubators
Installation
3-5