7 Care and maintenance
7.8
Cleaning the temperature sensor
As required
The appliance will not start without the base filter 1 in place.
▸ Remove the base filter 1.
▸ Clean the temperature sensor 2 with a
damp cloth.
▸ Insert the base filter 1.
7.9
Cleaning the additional filter mat and heat pump mat
As required or with «A11»
The appliance will not start without the base filter 1 in place.
▸ Remove the base filter 1.
▸ Take out the additional filter mat 2.
▸ Remove the fluff while dry from the addi-
tional filter mat 2. Next rinse under run-
ning water and then wring out.
▸ Wash on a 40 °C wash programme to
clean off heavier deposits.
▸ Clean the heat pump mat 3, behind the
grille, carefully using a brush and va-
cuum cleaner with the crevice tool at-
tachment.
28
1
2
3
2
1
3