Logging On To The Web Interface - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Logging On to the Web Interface

You can access the controller's web interface from any computer that is on the
same subnet as the Management (Web) interface, which you configured in
Configure the Management IP Address
Follow these steps to log on to the controller's web interface.
1 On a computer that is on the same subnet as the Management (Web) interface,
start a web browser.
2 In the address bar, enter the IP address that you assigned to the Management
(Web) interface and append a colon and 8443 (controller's management port
number) at the end of the address.
For example, if the IP address that you assigned to the Management (Web)
interface is 10.10.101.1, then you should enter:
https://10.10.101.1:8443
NOTE: While using HTTPS, as part of the security, the user is prompted to confirm
that the IP is safe to continue with.
The controller's web interface logon page appears.
Figure 29. The controller's web interface logon page
3 Log on to the controller's web interface using the following logon details:
• User Name: admin
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.4, 800-71126-001 Rev A
Running the Setup Wizard and Logging On to the Web Interface
Settings.
Logging On to the Web Interface
Step 2:
55