Ruckus Wireless SmartCell Gateway 200 Getting Started Manual page 61

Table 12. Configuration options in the Create New Zone form (Continued)
Option
Time Zone
AP IP Mode
Mesh Options
Enable
Radio Options
Radio Options b/g/n (2.4GHz) Configure the following 2.4GHz radio options:
Radio Options a/n/ac (5GHz) Configure the following 5GHZ radio options:
AP GRE Tunnel Options
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.4, 800-71126-001 Rev A
Description
Specify the time zone that you want this AP zone to use
by clicking one of the following options:
• System defined: Click this option, and then select a
time zone that you want to use.
• User defined: Click this option, and then define the
time zone settings (including the time zone
abbreviation, GMT offset, and daylight saving time
settings) that you want to use
Select the IP addressing mode that you want this AP
zone to use. Options include IPv4 Only, IPv6 Only and
Dual.
Select the Enable mesh networking in this zone check
box if you want managed devices that belong to this
zone to be able to form a mesh network automatically.
• Channelization: Select either 20MHz or 40MHz
channel width.
• Channel: Select Auto or manually assign a channel
for the 2.4GHz radio.
• TX Power Adjustment: Manually set the transmit
power on all 2.4GHz radios (default is Full).
• Channelization: Select 20MHz, 40MHz, or 80MHz
channel width.
• Channel (Indoor and Outdoor): Select Auto or
manually assign channels to the indoor and outdoor
5GHz radios.
• TX Power Adjustment: Manually set the transmit
power on all 5GHz radios (default is Full).
Configuring the SCG for the First Time
Creating an AP Zone
61