Hardware Troubleshooting - Yale Assure Lock YRL216 Installation And Programming Instructions

Hardware Troubleshooting

Cycle lock in both the locked and unlocked positions. If problems are found:
Bolt will not deadlock and/or lock signals failure via beeps
a. Check for sufficient clearance of the bolt within the strike-side jamb. Correct this by
increasing the depth of the pocket for the bolt.
b. Check for misalignment of bolt and/or strike which may be preventing bolt from
properly entering the strike. With the door open, extend and retract the bolt; if it is
smooth, check the strike alignment.
Bolt does not extend or retract smoothly and/or lock signals failure via beeps
a. Bolt and strike are misaligned, see above.
b. Check the backset of door relative to adjustments already made to bolt.
c. Verify proper door preparation and re-bore holes that are too small or misaligned.
d. Verify push button wire harness is routed properly (see Steps 2 - 4).
Push button numerics are scrolling
Remove interior lock and check to ensure that the wire harness is routed properly
(see Steps 2 - 4).
Thumbturn will not turn
a. Remove interior lock and ensure that thumbturn moves freely.
b. Ensure that spindle is in proper position(Step 2).
Key will not turn
a. Remove interior lock and ensure that key rotates freely.
b. Ensure that key cylinder is properly installed in lock (Step 6).
20
P/N YRL LPBINSTL FUL - - Rev A