Private Switch: Arista 7010T-48; Arista 7010T-48 Ports; Arista 7010T-48 Switch Configuration Detail - Dell EMC ECS D Series Hardware Manual

Switches

Private switch: Arista 7010T-48

D- and U-Series Hardware Guide
36
Note
1. The NAN (Nile Area Network) links all ECS Appliances at a site.
2. Ports 49 through 52 use CISCO 1G BASE-T SFPs (part number 100-400-141). In
an ECS Appliance, these four SFPs are installed in the 1 GbE switch. In a
customer-supplied rack order, these SFPs need to be installed.
The private switch is used for management traffic. It has 52 ports and dual power
supply inputs. The switch is configured in the factory.
Figure 10 Arista 7010T-48 ports
Table 21 Arista 7010T-48 switch configuration detail
Figure label Ports
1 1–24
2 25–48
3 49
3 50
4 51
5 52
6 Serial console The console port is used to manage the switch through a
Note
1. The NAN (Nile Area Network) links all ECS Appliances at a site.
2. Ports 49 through 51 contain SFPs (RJ45 copper). In an ECS Appliance or a
customer-supplied rack order, these four SFPs are installed in the 1 GbE switch.
Connection description
Connected to the MGMT (eth0) network ports on the nodes
(blue cables).
Connected to the RMM network ports on the nodes (gray
cables).
The 1 GbE management port. This port is connected to rabbit
(bottom) 10GB switch management port. See Note 2.
The 1 GbE management port. This port is connected to hare
(top) 10GB switch management port. See Note 2.
Rack/Segment Interconnect IN. See note 1 and 2.
52 Rack/Segment Interconnect OUT. See note 1 and 2.
serial connection. The Ethernet management port is
connected to the 1 GbE management switch.