Inputs; Table 12 Meas_Pressure: Input Parameters - Infineon SP37 Function Manual

2.2.4

Inputs

Table 12 Meas_Pressure: Input Parameters
Register / Address
R6 (MSB)
R7 (LSB)
R5
R3
*(PressResult+2)
*(PressResult+3)
*(PressResult+4)
ROM Library Function Guide
Type Name
unsigned int SensorConfig
unsigned char SampleRate
signed int PressResult
idata*
signed int RawTemperature Previous Raw Temperature value can optionally
signed int LowPressureThre
shold
signed int HighPressureThr
eshold
Tire Pressure Monitoring Sensor
Description
Defines Sensor Configuration (refer to
and Table 14)
Defines the number of system clock cycles
(12 MHz RC Oscillator) divided by 8 which is
waited between consecutive measurements.
Note: Only applicable if SensorConfig.2-0
[2POWN2:0] greater than 1 Sample
Pointer to an integer array in RAM to receive the
measurement result
be used as input parameter. Refer to bit
RAWTemp in SensorConfig.
(optional input parameter) Value for hysteresis
(in 1/16kPa) used by the pressure auto-range
selection to determine when to switch from High-
to-Low. It must be specified only if the parameter
SensorConfig.11 is set to 1 (Customer
Configuration)
(optional input parameter) Value for hysteresis
(in 1/16kPa) used by the pressure auto-range
selection to determine when to switch from Low-
to-High. It must be specified only if the
parameter SensorConfig.11 is set to 1
(Customer Configuration).
32
SP37
ROM Library Functions
Table 13
Revision 1.0, 2011-12-15