2N Lift1 Compact Brief Manual page 6

If you cannot access the cabin wall from the outside, use the screws under the pictogram glass:
 Insert the hex key wrench (included in the package) in the hole on the product bottom
edge and turn it left (about 10 times) until it puts up resistance.
 The window slides down by itself or with little assistance, showing its upper brim.
 Tilt the window forwards and remove it.
 Now you have access to two holes in the window corners. Put Lift1 on the pre-drilled lift
cabin wall holes and fit it
with the included screws,
which are
plywood,
laminated plastic etc. walls.
For other
appropriate screws or M4
screws in the pre-drilled M4
threaded holes.
 Replace the
insert the hex key wrench in
the bottom
turning it right about 10
times until
slides under the panel edge.
Tighten the window applying
a moderate force.
suitable for
chipboard,
materials, use
window and
edge hole
the window
5