Nikon Eclipse Series Instructions Manual page 6

1 Intended product use
This product should only be used for microscopic observation. Do not use it for any other purpose.
2 Do not disassemble
Disassembling may cause malfunction and/or electrical shock. Do not disassemble any parts other than those
mentioned in this manual. If you notice any malfunction, notify your dealer or nearest Nikon representative.
3 Read all instruction manuals thoroughly
To ensure safety, thoroughly study this instruction manual as well as the instruction manuals for all other units
being used. Adhere strictly to the warnings and cautions given at the beginning of these instruction manuals.
When using this product in combination with an Epi-fluorescence attachment, be sure to read its instructions.
Care is required when handling the mercury lamp used as the light source for the Epi-fluorescence attachment.
1 Turn the power off when assembling the system, connecting or disconnecting cables and
replacing the lamp
To prevent electrical shock and damage, be sure to switch off the power switches on the microscope, power
supply, etc., and to unplug the power cord from the wall outlet before connecting or disconnecting cables and
replacing the lamp.
2 Do not wet the instrument
If the microscope or the power supply gets wet, a short circuit may result that could damage the equipment or
make it extremely hot. If you accidentally spill a liquid on the instrument, immediately turn off the power switch
and unplug the power cord. Then use a dry cloth to wipe away the moisture. If any liquid gets inside the
instrument, do not use it; instead, notify your dealer or nearest Nikon representative.
3 Precautions for assembly
Be careful not to pinch your hands or fingers when assembling the instrument.
Safety Precautions
WARNING
CAUTION
iv