Assembly For The Dual-Viewing (Side-To-Side) Model - Nikon Eclipse Series Instructions Manual

2

Assembly for the dual-viewing (side-to-side) model

Assemble the system in the order of the numbers ([1] to [7]) in the figure below.
 Check that the serial numbers on the two components (main observer section and secondary observer section)
of the teaching head S-S are identical. (If the numbers are different, observation will be adversely affected. In
this case, please contact your dealer or nearest Nikon representative.)
 Adjust the height of the support stand so that the main observer section and the secondary observer section
are horizontal. This step is facilitated by first adjusting the support stand to an approximate height before
attaching the stand.
 When a pointer is going to be used, assemble the system so that the secondary observer will be positioned on
the right. If reversed, the pointer control section will be at the rear of the microscope.
[3]
Clamp for [3]
Pointer mounting surface
[2]
Clamp for [2]
Chapter 3
Assembly
[1]
[5]
Clamp for [5]
Main observer
section
Place
horizontally
6
Check that the
serial numbers of
the teaching head
S-S are the same.
[7]
Secondary
observer
section
[4]
Height adjustment clamp screw
Adjust to an approximate height
and readjust later.
Upper surface should
also be horizontal.
Clamp for [7]
[6]
Clamp for [6]