Advertisement
The items below are required for assembly
1. Find a flat work bench and place both L & R wings
on top. Align the wing properly and glue it together with
CA glues shown. Use a straight edge and place on top
of the wing to check while the glue set to ensure the
wing is perfectly flat.
2. There are 3 carbon rods supplied in the kit to rein-
force the wing joint. Install 2 carbon rods into the
pre-cut slot which located top and bottom as shown in
picture. Then locate the third carbon rod to the wing
bottom as shown. Add CA glue into the slot and let it
dry.
3. Please ensure the motor mount is true and
levelled with the plane axis. The motor thrust angle
should be aligned to the wing axis otherwise it will
affect the flying performance. Once satisfied about
the fit, apply CA glue to secure it in place.
4. Install the battery holder with velcro tape to the wing
and secure it by using CA glue.
5. Insert the supplied zip tie to the pre-cut hole of the
wing. These zip ties will hold your ESC and RX in the
recess area as shown.
6. Install the pushrod connector onto the farthest hole
the servo horn screw by a Philips screw driver. Please
follow the same steps for the other wing servo.
2
on the servo arm
from the servo
output axis.
Then install the
servo arm onto
the servo, please
ensure the servo
arm is in neutral
position. once
statisfied the
setup, tightened
Advertisement
