Advertisement
Quick Links
Advertisement
Related Manuals for H-KING j-20
Summary of Contents for H-KING j-20
- Page 1 INSTRUCTION M ANUA L...
-
Page 3: Packing List
Packing list: 1: PP J20 fuselage *1 2: Carbon strip 1mm*3 3: Carbon strip 0.5mm * 2 4: Pull rod *2 5: Motor mount *1 6: Quick rod adjuster *2 7: Hinge*2 8: Hook and loop tape*1 Tools: 1: 1.5mm allen wrench 2: Phillips screwdriver 3: Modelling knife 4: Wire cutters... - Page 4 Glue the 2 pcs horizontal fuselages using hot glue Then put the 3 pcs carbon strips into horizontal sticks. fuselage using No.502 glue. Stick the 2 pcs carbon strips on vertical tail using foam glue. Press the 2 pcs vertical fuselages into horizontal fuselage.
- Page 5 Applying glue on 2 pcs vertical fuselages using foam Assemble bottom fuselage on vertical fuselage. glue sticks. Important: Just glue top side. Reinforce bottom fuselage using hot glue sticks after assembly. Then wait glue dried. Then take down bottom fuselage with 2 pcs vertical Reinforce bottom fuselage using hot glue sticks inside.
- Page 6 Applying foam glue on 2 pcs nose. Important: Wait 3 mins after applying foam glue, then assemble the 2 pcs nose. Make sure 2 pcs nose trim. Especially for step. Assemble the nose on fuselage using hot glue sticks Reinforce nose using hot glue sticks after assembly. or foam glue, make sure the motor mount location must be flat! Install vertical tail on fuselage using hot glue sticks.
- Page 7 Assemble motor on motor mount using motor’s screws. Then install prop on motor. Notice the prop’s direction. Assemble motor mount on fuselage, reinforce motor Put hook and loop tape on fuselage using foam glue. mount using a little hot glue sticks. Then install ESC .
- Page 8 Then install the pull on the quick rod adjuster and Put hook and loop tape on fuselage using foam glue. hinge. Adjust pull rod’s length and tighten the screw. Then install battery. Let battery cable through the hole to fix battery. Put hook and loop tape near battery using foam glue.