Advertisement
13. Connect the esc and motor, but please confirm
the direction of motor rotation before flying.
14. Connect the servo plug and esc plug to the
15. Install the EPP skid onto the nose of the flying
16. Install the fins on both wing tip and secure it with
CA glue.
Glue
Glue
Glue
Glue
Glue
17. A roll of fiberglass tape is supplied in the kit.
receiver, and
then test, finally
using the plastic
band to fix the
receiver into the
equipment
compartment.
wing so that it
can prevent from
damaging the
NOTE: Please adjust the C of G (200-212mm) accord-
battery or receiv-
ing to the diagram before you attempt to fly the wing. If
er upon landing.
you do not follow the C of G closely, it will fly in an
Fix the battery by
uncontrollable manner and it may also causes plane
using velcro
crash or hitting someone or any properties nearby the
flying field.
strap.
The flight performance will be affected by adding extra
weight on the Teksumo. So you should reduce any
unnecessary weight while assembly. Then you'll get the
best possible flying performance!
Please use it to
reinforce the
leading edge of
the wing and
some of the areas
on the wing that
need to be rein-
forced.
4
FINISHED PRODUCT
ENJOY !
200-212mm
Advertisement
