Mode Window Options; Temperature Set Point - ActronAir Que Touch Series User Manual

Mode Window Options

From the home screen, touch the operation status display to
reveal the adjustable options.
Operation Mode:
Available options are Auto, Cool, Heat and Fan Mode
Fan Speed:
Available option are Auto (if applicable), High, Medium and Low
fan speeds.
NOTE:
Auto Fan is a variable fan technology that automatically adjusts airflow
depending on zone/s demand. The system will maintain the right amount
of airflow anytime no matter how many zones are open or closed. Auto is
only available in a zoned system.
Other Options:
Toggle the switch to the right to activate the selected option.
Available options are:
Constant fan - Indoor fan will continuously run regardless
if set temperature is achieved.
Away mode - The system will use Away Mode temperature
settings.
Quiet mode - The system limit system capacity to lessen
the sound of operation.
NOTE:
It is possible to change the option anytime even when OFF.
The system will be on selected options when turned ON.
10
Operation mode Fan speed Other options

Temperature Set Point

To adjust temperature set point, touch the screen on the set point area to
reveal the ' ' and ' ' adjustment icon. Touching ' ' will increase set point
temperature, while touching ' ' will decrease the value.
Auto Mode
In Auto Mode, there are two adjustable set point temperatures. These
temperatures are also called 'Set Temperature Range'. During operation,
the system will always maintain the room temperature within this range.
The left temperature is 'Heat to' set point. When the room temperature
falls below this temperature, system will start heating until 'Heat to' set
point is achieved.
The right temperature is 'Cool to' set point. When the room temperature
is above this temperature, the system will start cooling until 'Cool to' set
point is achieved.
NOTE:
'Cool to' setpoint is always higher than 'Heat to' set point. Minimum temperature
difference between the two (deadband) is 1.
o
Cool / Heat Mode
Shows only one set temperature. In cooling, when the room
temperature is above this temperature, the system will cool until this
set point is achieved. In heating, when the room temperature falls
below this temperature, the system will heat until this set point is
achieved.
Fan Mode
Will not show the set temperature. The system will only circulate air.
Touch to reveal adjustment icon
Touch to reveal adjustment icon
Fan Mode
11