Door - Osburn 1700-I Installation And Operation Manual

Hide thumbs Also See for 1700-I:
Table of Contents

Advertisement

6.
Cut the gasket to the required length.
7.
Pinch the gasket onto the glass in a U shape, all around the glass.
6.3

Door

In order for the insert to burn at its best efficiency, the door must provide a perfect seal with the
firebox. Therefore, the gasket should be inspected periodically to check for a good seal. The
tightness of the door seal can be verified by closing and latching the door on a strip of paper.
The test must be performed all around the door. If the paper slips out easily anywhere, either
adjust the door or replace the gasket.
6.3.1
Adjustment
The gasket seal may be improved with a simple latch mechanism adjustment:
1.
Remove the split pin by pulling and turning it using pliers.
2.
Turn the handle one counterclockwise turn to increase pressure.
3.
Reinstall the split pin with a small hammer.
Figure 17: Removing the split pin
Installation and Operation Manual - Osburn 1700-I
Figure 16: Door gasket seal verification
Figure 18: Installing the split pin
Page 25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ob01705

Table of Contents