Wen 56380i Manual page 31

BATTERY MAINTENANCE/STORAGE
The lithium-ion battery will receive charge when the engine is running. Remember to run the generator once
a month for 20-30 minutes to charge the battery. A charged battery will allow you to start the generator us-
ing the electric start button during your next time of need. If the battery is out of charge, you may start the
generator using the recoil starter.
If the generator is not used for a long period, it is recommended to disconnect the negative (black) battery
cable from the battery to protect it from losing charge. After disconnecting the cable, cover the free end with
an insulator such as electrical tape.
TIP: You can also connect the battery to an automatic trickle charger to keep the battery charged.
To reinstall/replace the battery:
1. Using a quarter coin or flat-head screwdriver (not included),
open and remove the battery access cover (Fig. 33).
2. Loosen the rubber belts and pull out the battery (Fig. 34).
3. Disconnect the negative (-) battery terminal first (black
cable).
4. Disconnect the positive (+) battery terminal second (red
cable).
5. Replace with an identical new battery (part no. 56380i-
1304).
6. Connect the positive (+) battery terminal (red cable) first.
Slide rubber boot over the positive terminal.
7. Connect the negative (-) battery terminal (black cable) sec-
ond. Slide rubber boot over the negative terminal.
8. Return the battery into position and use the rubber belts to
fasten the battery.
9. Reinstall and secure the battery access cover.
NOTE: Always recycle used batteries in accordance with local laws and regulations. Contact your local solid
waste collection site or recycling facility to obtain information on local recycling processes.
MAINTENANCE
Rubber Belts
Battery
Access
Cover
Fig. 33
Fig. 34
31