Wen 56380i Manual page 20

KNOW YOUR CONTROL PANEL
Become familiar with the functions and capacity of each component on the control panel.
CONNECTING ELECTRICAL DEVICES
CAUTION:
Before connecting devices, become familiar with the markings on the control panel before
connecting electrical devices. The 120V AC receptacles are for connecting electrical devices that run on
120V, 60 Hz, single phase, AC current. DO NOT connect 50Hz or 3-phase loads to the generator.
Follow the steps below to properly connect your device(s) to the generator:
1. Before connecting electrical devices, allow the generator to run for a few minutes to stabilize the speed
and voltage output.
2. Select the device with the highest wattage, and make sure it is turned off. Plug the device into the genera-
tor and then turn the device on. Allow the engine to stabilize.
3. Repeat step 2 to plug in each additional device. DO NOT attempt to plug in or start multiple devices at the
same time.
20
USING THE GENERATOR
Fig. 14 - Control Panel