Wen 56380i Manual page 17

3800 watt inverter generator
Hide thumbs Also See for 56380i:
Table of Contents

Advertisement

Before starting the generator:
1. Verify that the generator is outside on a dry, level surface. Allow at least two feet of clearance on all sides
of the generator.
2. To maximize safety, check that the generator is properly grounded (see "GROUND THE GENERATOR").
3. Check there is sufficient level of oil in the crankcase. Add oil if necessary (see "ADD/CHECK OIL").
4. Make sure there is sufficient level of gasoline in the fuel tank. Add fuel if necessary (see "ADD/CHECK FUEL").
5. Make sure all electrical devices are unplugged from the generator during ignition. Otherwise it will be dif-
ficult for the engine to start.
To start the generator, perform the following steps:
1. Turn the ECO-MODE (Fig. 10) switch to "OFF" during starting.
2. Turn the 3-in-1 dial switch (Fig. 11) to the "START" position.
NOTE: If starting the generator with a warm engine, turn the
dial switch to the "RUN" position.
Option A: Electric Start:
3. Push the start button in-
wards until the engine starts.
NOTE: If the engine does not
start, release the button and
try again. Keeping the switch
in the START position too long
can damage the starter.
4. When engine starts, re-
lease the switch to the "RUN"
position.
NOTE: If you have repeated failed attempts to start the engine,
please consult the troubleshooting guide (page 31). If problems
persist please call (800) 232-1195 M-F 8-5 CST.
5. After the engine has started, turn the 3-in-1 switch to the
"RUN" position. The output indicator light (green) will light up.
6. Allow the generator to run for several minutes before at-
tempting to connect any electrical devices. This allows the
generator to stabilize its speed and temperature.
STARTING YOUR GENERATOR
Option B: Pull Start
3. Place one hand on the
generator to hold it in place,
and pull on the recoil starter
handle slowly until a slight re-
sistance is felt (Fig. 12). Then
pull quickly to start the en-
gine. Return cord gently into
the machine. Never allow the
cord to snap back.
4. If engine fails to start,
repeat step 3B.
Fig. 10
Start Button
Fig. 11
Fig. 12
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents