Safety Instructions - Maxxus 4.2i Installation & Operating Manual

Index

Safety Instructions

Overview of the Device
Assembly Material and Tools
Scope of Delivery
Assembly
Folding Mechanism
Transport
Mains Cable
Safety Key
What to do in an Emergency
Care, Cleaning & Maintenance
Lubricating the Treadmill Belt
Adjusting the Treadmill Belt
Re-Tensioning the Treadmill Belt
Cockpit
Heart Rate Measurement
Warning about Pulse and Heart Rate Monitoring
Pulse Monitoring using Hand Sensors
Heart Rate Monitoring using a Chest Belt
Training Recommendations
Technical Details
Disposal
Recommended Accessories
Explosion Drawing
Parts List
Warranty
Repairs Contract / Notification of Damage Claim
Notes
© 2015 by MAXXUS Group GmbH & Co. KG
All rights reserved
This publication may not be reproduced, stored in retrieval system, or transmitted on whole or in part, in any form or by any means, electronic, mechanical, photocopying,
recording, or otherwise, without the prior written permission of Maxxus Group GmbH & Co. KG.
Errors, colour and technical modification subject to change, reproduction as well as electronic duplication only with written permission of MAXXUS Group GmbH & Co. KG.
Index
2
Please read and observe all sections of this Operating Manual. Thorough attention should be paid to the safety, service and
2
maintenance instructions and adherence to the given training information at all times.
3
It is very important to adhere strictly to the service and maintenance instructions contained in this Manual.
4
This training device is only to be used for it's intented purpose.
If this equipment is used for any other purposes than intended, there will be a possible risk of accident, damage to health or
4
damage to the training device. The Distributor cannot be held responsible in this case.
4
Electrical Connection
5 – 6
− A mains voltage of 220-230V is required to operate this training device.
− The training device is only to be connected to the mains with the mains cable supplied using a 16A individually fused
6 – 7
and earthed socket installed by a qualified electrician.
− The training device is only to be switched on and off using the ON/OFF switch.
8
− Always remove the electric plug from the socket before moving the training device.
− Remove the electric plug from the socket before commencing any cleaning, maintenance or other works.
9
− Do not connect the mains plug to a socket on a socket strip or on a cable drum.
− If using a cable extension please ensure that this complies with VDE guidelines and regulations.
9
− Always place the mains cable so it cannot be damaged or cause a tripping hazard.
− In operating or standby mode, electrical devices such as mobile phones, PCs, Televisions (LCD, plasma, tube, etc.),
10
game consoles etc. will emit electro-magnetic radiation. For this reason, all these types of devices should be kept
away from your training device as they could lead to malfunction, disturbances or false outputs being shown in heart
11
rate measurements.
12
Training Environment
− Select a suitable space for your training device to provide an optimum amount of free space and highest level of safe-
13
ty. You should leave a free space of at least 200 cm long and 100 cm wide behind the training device. A minimum of
13 100 cm free space to each side and in front of the training device should be allowed for.
− Make sure that the area is well ventilated and that an optimum amount of oxygen is available during training. Avoid
14 – 20
drafts.
− Your training device is not suitable for outside use and so storage and training can only take place in a temperate, dry
21
and clean room.
− Operation and storage of your training device in wet areas such as in swimmingpools, saunas etc. is not possible.
22
− Make sure that your training device is is kept on flat, hard and clean ground both in operation and at stillstand. Any
uneven surfaces must be romoved or made good.
22
− It is recommended that a floor covering (carpet, mat, etc.) should be placed under the device to protect damageable
floors such as wood, laminates, floor tiles etc. Please ensure that this underlay cannot slip or slide.
22
− Do not put this training device on pale or white coloured carpets or rugs as the feet of the device may leave marks.
− Make sure that your training device and mains cable are kept out of contact with hot items and are kept at a safe dis-
23 – 24
tance from any sources of heat eg. central heating, hot stoves, furnaces, ovens or open fires.
25
Personal Safety Instructions for Training
− The safety key must be inserted correctly before each training session can begin.
25
− Remove the safety key and mains cable from the training device when not in use to avoid inappropriate or uncontrolled
use by any other third party, eg. children.
25
− Stop training immediately if you feel physically unwell or are experiencing any breathing difficulties.
26 − Always start your training session at a low workload increasing it slowly but steadily throughout. Reduce the workload
again towards the end of your training session.
27 – 28 − Suitable sports shoes and clothes should always be worn during training sessions. Make sure that loose clothes do not
get caught up in the treadmill belt or rollers.
29
− Your training device is only to be used by one person at a time.
− Check each time before a training session to see if your device is in perfect condition. Never use your training device if
30
it is faulty or defect.
− You are only permitted to carry out repairs to the device yourself after having contacted our Service Department and
31
on receipt of explicit permission to do so. Only original spare parts may be used at any time.
− Your training device must be cleaned after each use. Remove all dirt including body sweat or any other liquids.
− Always make sure that liquids (drinks, body sweat, etc.) do not get into the vibrating plate or into the cockpit as this can
cause damage to the mechanical and electronic components.
− Your training device is not suitable to be used by children.
− Third parties, in particular children and animals, must be kept at an appropriate safety distance during training.
− Check before each training session if there are any items underneath the training device and remove them without fail.
Never use the training device when items are underneath it.
− Do not allow children to misuse your training device as a toy or climbing frame at any time.
− Ensure that no body parts of your own or other third parties ever come into contact with any of the moving mecha-
nisms.
The construction of this training device is based on state of the art technology and highest modern technical safety stand-
ards. This training device is to be used by adults only!
Extreme misuse and/or unplanned training can cause damage to your health!
Safety Instructions
3