Technical Specifications - Seco SBC-A62-J User Manual

Single board computer with nxp i.mx6 processor
Table of Contents

Advertisement

2.2 Technical specifications

Processors
®
NXP i.MX6 Family, based on ARM
-
i.MX6S Solo - Single core up to 1GHz
-
i.MX6DL Dual Lite - Dual core up to 1GHz per core
-
i.MX6DP Dual Plus - Dual core up to 1GHz per core
-
i.MX6Q Quad - Quad core up to 1GHz per core
Memory
Soldered down DDR3L memory
i.MX6DP: 2GB 64-bit interface
i.MX6Q, i.MX6DL: 1GB 64-bit interface
i.MX6S: up to 512MB 32-bit
Graphics
Dedicated 2D Hardware accelerator
Dedicated 3D Hardware accelerator, supports OpenGL
Dedicated Vector Graphics accelerator, supports OpenVG
i.MX6Q)
Supports up to 3 independent displays with i.MX6DP and i.MX6Q
Supports 2 independent displays with i.MX6DL and i.MX6S
Video Interfaces
1 x LVDS Dual Channel or 2 x LVDS Single Channel 18/24 bit interface
HDMI Interface
MIPI-CSI Camera connector
Video Resolution
LVDS, up to 1920x1200
HDMI, resolution up to 1080p
Mass Storage
Optional on-board eMMC Disk, up to 16GB *
SATA connector (only i.MX6DP and i.MX6Q)
microSD card slot
SPI Flash soldered onboard
* Please consider that for HDD and Flash Disk manufacturers, 1GB = 10^9 Byte.
Some OS (like, for example, Windows) intends 1GB = 1024^3 byte, so global
capacity shown for Disk Properties will be less than expected. Please also consider
that a portion of disk capacity will be used by internal Flash Controller for Disk
management, so final capacity will be lower
CORTEX-A9 processors
®
ES2.0 3D
(only i.MX6DP and
Networking
Gigabit Ethernet connector
USB
2 x standard USB 2.0 Type A
Internal USB 2.0 connector
1 x USB micro-B client connector
Audio
AC'97 Audio Codec Realtek ALC655
Mic In, Line out Audio jacks
Serial Ports
Optional CAN Bus connector
Other interfaces
I2C touch Connector
32-pin expansion connector, configurable to offer:
Up to 28 GPIO
SPI interface
SPDIF Audio interface
2 x CAN interface (TTL level)
SDIO interface
3 x PWM
2 x I2C
3 x UARTs (TTL, RS-232, RS-485 modes)
Debug UART on dedicated connector
Power and reset buttons
Power supply voltage: +12V
± 10%
DC
Embedded additional RTC circuitry for lowest power consumption
Operating temperature:
0°C ÷ +60°C** (commercial version)
-40°C ÷ +85°C** (industrial version)
Dimensions: 110 x 86.5 mm (4.5" x 3.7").
Supported Operating Systems:
Linux
Android
** is to be considered at any point of the heatspreader/heatsink. Actual
temperature will widely depend on application, enclosure and/or
environment.
p to the customer to consider specific cooling solutions
for the final system.
Please also check paragraph 4.1

Advertisement

Table of Contents
loading

Table of Contents