Operation Mode - ABB ACS880 Firmware Manual

No. Name/Value
19

19 Operation mode

19.01 Actual operation
mode
Zero
Speed
Torque
Min
Max
Add
Scalar (Hz)
Scalar (rpm)
Forced magn.
19.11 Ext1/Ext2 selection
EXT1
EXT2
MCW bit11: Ext ctrl
loc
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
19.12 Ext1 control mode 1
Zero
Speed
Torque
Description
Selection of external control location sources and operating
modes.
See also section Operating modes of the drive
Displays the operation mode currently used.
See parameters 19.11...19.14.
This parameter is read-only.
None.
Speed control (in DTC motor control mode).
Torque control (in DTC motor control mode).
The torque selector is comparing the output of the speed
controller (25.01 Torque reference speed
reference (26.74 Torque ref
two is used.
The torque selector is comparing the output of the speed
controller (25.01 Torque reference speed
reference (26.74 Torque ref
two is used.
The speed controller output is added to the torque reference.
Frequency control in scalar motor control mode.
Speed control in scalar motor control mode.
Motor is in magnetizing mode.
Selects the source for external control location EXT1/EXT2
selection.
0 = EXT1
1 = EXT2
EXT1.
EXT2.
06.01 Main control word
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
Selects the operating mode for external control location
EXT1.
None.
Speed control. The torque reference used is
reference speed control
chain).
Torque control. The torque reference used is
ramped (output of the torque reference chain).
(page 20).
control) and torque
ramped) and the smaller of the
control) and torque
ramped) and the greater of the
(page 79), bit 11.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 73).
25.01 Torque
(output of the speed reference
26.74 Torque ref
Parameters 99
Def/FbEq16
-
1
2
3
4
5
6
10
11
20
EXT1
0
1
2
3
4
5
6
7
8
11
12
-
Speed
1
2
3