Supervision - ABB ACS880 Firmware Manual

150 Parameters
No. Name/Value
32

32 Supervision

32.01 Supervision status
Bit Name
0 Supervision 1 active
1 Supervision 2 active
2 Supervision 3 active
3...15 Reserved
000...111b
32.05 Superv1 function
Disabled
Low
High
Abs Low
Abs High
Both
Abs Both
32.06 Superv1 action
No
Warning
Fault
32.07 Superv1 signal
Zero
Speed
Frequency
Current
Description
Configuration of signal supervision functions 1...3.
Three values can be chosen to be monitored; a warning or
fault is generated whenever predefined limits are exceeded.
See also section Signal supervision
Signal supervision status word.
Indicates whether the values monitored by the signal
supervision functions are within or outside their respective
limits.
Note: This word is independent of the drive actions defined
by parameters 32.06, 32.16
Description
1 = Signal selected by
1 = Signal selected by
1 = Signal selected by
Signal supervision status word.
Selects the mode of signal supervision function 1. Determines
how the monitored signal (see parameter 32.07) is compared
to its lower and upper limits
The action to be taken when the condition is fulfilled is
selected by 32.06.
Signal supervision 1 not in use.
Action is taken whenever the signal falls below its lower limit.
Action is taken whenever the signal rises above its upper
limit.
Action is taken whenever the absolute value of the signal falls
below its (absolute) lower limit.
Action is taken whenever the absolute value of the signal
rises above its (absolute) upper limit.
Action is taken whenever the signal falls below its low limit or
rises above its high limit.
Action is taken whenever the absolute value of the signal falls
below its (absolute) low limit or rises above its (absolute) high
limit.
Selects the action the drive takes when the value monitored
by signal supervision 1 exceeds its limits.
Note: This parameter does not affect the status indicated by
32.01 Supervision status.
No action taken.
A warning (A8B0 Signal
The drive trips on 80B0 Signal
Selects the signal to be monitored by signal supervision
function 1.
None.
01.01 Motor speed used
01.06 Output frequency
01.07 Motor current (page 76).
(page 54).
and 32.26.
32.07 is outside its limits.
32.17 is outside its limits.
32.27 is outside its limits.
(32.09 and 32.10 respectively).
supervision) is generated.
supervision.
(page 76).
(page 76).
Def/FbEq16
000b
1 = 1
Disabled
0
1
2
3
4
5
6
No
0
1
2
Zero
0
1
2
3