Default Control Connections For The Hand/Auto Macro - ABB ACS880 Firmware Manual



Default control connections for the Hand/Auto macro

Fault
XPOW External power input
1 +24VI
24 V DC, 2 A
2 GND
XAI Reference voltage and analog inputs
1 +VREF 10 V DC, R
2 -VREF -10 V DC, R
3 AGND Ground
4 AI1+ Speed reference (Hand)
0(2)...10 V, R
5 AI1-
6 AI2+ Speed reference (Auto)
0(4)...20 mA, R
7 AI2-
XAO Analog outputs
1 AO1 Motor speed rpm
0...20 mA, R
2 AGND
3 AO2 Motor current
0...20 mA, R
4 AGND
XD2D Drive-to-drive link
1 B
2 A Drive-to-drive link
3 BGND
XRO1, XRO2, XRO3 Relay outputs
1 NC
2 COM
3 NO
1 NC
2 COM
3 NO
1 NC
2 COM
3 NO
XD24 Digital interlock
1 DIIL Digital interlock. By default, not in use.
2 +24VD +24 V DC 200 mA
3 DICOM Digital input ground
4 +24VD +24 V DC 200 mA
5 DIOGND Digital input/output ground
XDIO Digital input/outputs
1 DIO1 Output: Ready
2 DIO2 Output: Running
XDI Digital inputs
1 DI1 Stop (0) / Start (1) – Hand
2 DI2 Forward (0) / Reverse (1) – Hand
3 DI3 Hand (0) / Auto (1)
4 DI4 Constant speed 1 (1 = On)
5 DI5 Forward (0) / Reverse (1) – Auto
6 DI6 Stop (0) / Start (1) – Auto
Safe torque off circuits must be closed for the drive to start. See
XSTO
Hardware manual of drive.
X12 Safety options connection
X13 Control panel connection
X205 Memory unit connection
Application macros 61
1...10 kohm
L
1...10 kohm
L
> 200 kohm
in
> 100 ohm
in
< 500 ohm
L
< 500 ohm
L
Ready
250 V AC / 30 V DC
2 A
Running
250 V AC / 30 V DC
2 A
Faulted(-1)
250 V AC / 30 V DC
2 A