Closing Down The System - Schaudt EBL 101 D Instruction Manual

811.554 BA / EN
Instruction Manual EBL 101 D / EBL 101 C with OVP
Fault
Solar charger does not
work (power supply and
engine are off) g )
12V supply does not work 12V supply does not work
in the living area g
The Electroblock cannot
be operated from the DT be operated from the DT
... control and switch pa-
nel
The charging current is reduced automatically if the device becomes too
Y
hot due to excessive ambient temperature or lack of ventilation. Always
prevent the device from overheating nevertheless.
If the automatic shutdown mechanism of the battery monitor is triggered,
Y
fully charge the living area battery.
3.4

Closing down the system

ATTENTION!
Y
Total discharge.
Damage to the living area battery:
Fully charge the living area battery before and after closing down the
F
system. Connect a vehicle with an 80 Ah battery and a vehicle with a
160 Ah battery to the mains for at least 12 and 24 hours respectively.
ATTENTION!
Y
Permitted input voltages exceeded.
Damage to connected consumers:
Do not operate any connected Schaudt solar charge regulator without
F
battery.
When the battery is changed or removed, first unplug the "+ solar cell"
F
connector on the solar charge regulator.
Possible cause
Solar panel in (partial)
shade or covered (snow or
dirt)
Solar charge regulator not Solar charge regulator not
plugged in
Defective fuse or wiring Defective fuse or wiring
Solar charge regulator de-
fective
12V main switch for the li- 12V main switch for the li
ving area battery is swit- g
ched off
Activate battery isolation
on the DT ... control and on the DT control and
switch panel
Defective fuse or wiring Defective fuse or wiring
Defective Electroblock
Defective Electroblock
Date: 29.04.2010
Remedy
Move solar panel out of
shade or clean.
Plug in solar charge regu Plug in solar charge regu-
lator
Check fuse and wiring Check fuse and wiring
Check solar charge regu-
lator
12V main switch for the li- 12V main switch for the li
y ving area battery must be g
switched on
Activate battery isolation
on the DT ... control and on the DT
switch panel
Check fuse and wiring Check fuse and wiring
Call customer service
Call customer service
y
control and
7