Pairing A Zone Controller - ActronAir QUE QZB-100 Installation And User Manual

Pairing a Zone Controller

On master controller, go to 'MENU' > Settings > System Settings>
1
Zone Settings, then select which zone to set up.
2 Assign a named to the zone, then touch 'Add a zone device'.
3 Touch 'A new zone controller'.
Follow the on screen instructions.
4
10
Press and hold the 'Pair' button until 3 green light flashes
5
(on the button).
NOTE:
3 red flashes means the device failed to pair to master controller.
Retry pairing the zone controller.
6
If successful, master controller will show that the device is paired.
Confirm the serial number of the zone controller then touch
to accept.
NOTE:
Zone controller serial number is printed on the back of the device.
Next screen will show the paired zone controller and its
serial number.
If a remote sensor is required, repeat steps 1-6. However, at step 3
select 'A remote sensor' then follow the on screen instructions.
Welcome! Connecting Connected Not Co
Device is not connected This device is now This device is now connected This devic
to the AC trying to connect to the main controller. to the m
to the main controller.
Please go to the main Please return to the main Please r
controller to setup. Please wait controller to complete setup. control
Pair
button
Software Update
Software Update Software Update
WARNING! This device is now This device failed to
The battery level is low. downloading software. update software!
Please wait... Error code X
Please replace the batteries Press any button to try again.
to update software.
11