Pairing A Zone Controller - ActronAir que QZW-100 Installation And User Manual

Pairing a Zone Controller

On master controller, go to 'MENU' > Settings > System Settings>
1
Zone Settings, then select which zone to set up.
Assign a named to the zone, then touch 'Add a zone device'.
2
3 Touch 'A new zone controller'.
Follow the on screen instructions.
4
10
Press and hold the 'Pair' button until 3 green light flashes
5
(on the button).
NOTE:
3 red flashes means the device failed to pair to master controller.
Retry pairing the zone controller.
6
If successful, master controller will show that the device is paired.
Confirm the serial number of the zone controller then touch
to accept.
NOTE:
Zone controller serial number is printed on the back of the device.
Next screen will show the paired zone controller and its
serial number.
If a remote sensor is required, repeat steps 1-6. However, at step 3
select 'A remote sensor' then follow the on screen instructions.
Welcome!
Device is not connected
to the AC
Please go to the main
controller to setup.
Pair
button
11