Operators Safety Summary - Tektronix 2213 Instruction Manual

2213 Service

OPERATORS SAFETY SUMMARY

The general safety inform ation in this p art o f the summary is fo r both operating and servicing personnel. Specific warnings
and cautions w ill be found throughout the manual where they apply and do n o t appear in this summary.
Terms in This Manual
CAUTION statements identify conditions or practices
that could result in damage to the equipment or other
property.
WARNING statements identify conditions or practices
that could result in personal injury or loss o f life.
Terms as Marked on Equipment
CAUTION indicates a personal injury hazard not imme­
diately accessible as one reads the markings, or a hazard to
property, including the equipment itself.
DANGER indicates a personal injury hazard immediately
accessible as one reads the marking.
Symbols in This Manual
This symbol
cautionary or other information is to be
A
found. For maximum
Table 1-1.
Symbols as Marked on Equipment
DANGER — High voltage.
Protective ground (earth) terminal.
ATTENTION — Refer to manual.
Power Source
This product is intended to operate from a power source
that does not apply more than 250 volts rms between the
supply conductors or between either supply conductor and
ground. A protective ground connection by way o f the
grounding conductor in the power cord is essential fo r safe
operation.
Vi
indicates where applicable
input voltages, see
Grounding the Product
This product is grounded through the grounding conductor
o f the power cord. To avoid electrical shock, plug the
power cord into a properly wired receptable before con­
necting to the product input or output terminals. A
protective ground connection by way o f the grounding
conductor in the power cord is essential fo r safe operation.
Danger Arising From Loss of Ground
Upon loss o f the protective-ground connection, all acces­
sible conductive parts (including knobs and controls that
may appear to be insulating) can render an electric shock.
Use the Proper Power Cord
Use only the power cord and connector specified fo r
your product.
Use only a power cord that is in good condition.
For detailed information on power cords and connectors
see Figure 2-1.
Use the Proper Fuse
To avoid fire hazard, use only a fuse o f the correct type,
voltage rating and current rating as specified in the parts
list fo r your product.
Do Not Operate in Explosive Atmospheres
To avoid explosion, do not operate this product in an
explosive atmosphere unless it has been specifically cer­
tifie d fo r such operation.
Do Not Remove Covers or Panels
To avoid personal injury, do not remove the product
covers or panels. Do not operate the product w ithout the
covers and panels properly installed.
@