Garmin G3X Touch Pilot's Manual page 59

EIS DISPLAY LOCATION (OPTIONAL)
In Configuration Mode the 'EIS Display Location' setting can be set to one of the
following:
• AUTO—Displays the EIS Strip on the MFD, or on the PFD1 (and PFD2 if applicable)
if the MFD is not displayed.
• PFD—Always displays the EIS Strip on PFD1 (and PFD2 if applicable).
• User Selected—Enables the user to choose between 'AUTO' and 'PFD' via the
Display Setup menu.
For more information on how to enable the 'EIS Display Location' setting in
Configuration Mode refer to the G3X Touch Installation Manual.
SCREENSHOT
Saving a Screenshot to the SD Card (if Screenshot function is
enabled):
1) Navigate to the desired screen.
2) Press and hold the MENU Key. A 'Screenshot saved to card' message will
appear.
SCREEN CLEANING
Cleaning the display:
1) Press the MENU Key twice.
2) Touch Tools > Screen Cleaning.
3) Clean screen with a clean, lint-free cloth (such as the Garmin cleaning
cloth). Avoid any chemical cleaners or solvents that can damage plastic
components.
4) Per the on-screen instructions, press the MENU Key to swap sides of the
display, or press the BACK Key to return to Tools.
NOTE: Make sure that no dust or grit accumulates at the bottom of the display
glass. The GDU displays use invisible infrared beams for touch detection, this
makes it very important to keep the screen clean, especially along the edges.
190-01754-00 Rev. L Garmin G3X Touch Pilot's Guide
System Overview
39