Recording Continuous Timecode Over Fam Connections - Sony PDW-70MD Instructions For Use Manual

Professional disc recorder

Table of Contents

Enlarged version

i.LINK cable is connected: Disconnect the i.LINK cable

from either this unit or the remote computer, wait for

at least 10 seconds, and then reconnect the

disconnected cable.

The unit is powered off and an i.LINK cable is

connected: Power the unit on.

To disable FAM connections

Execute one of the procedures described in the previous

section "To make a reconnection" to make a FAM

connection between this unit and the remote computer. To

disable FAM connections, in the setup menu, set

INTERFACE SELECT >i.LINK MODE to "AV/C" (see

page 71).

Recording Continuous Timecode Over FAM Connections

Recording Continuous

Timecode Over FAM

Connections

For clips created over a FAM connection, you can record

so that the timecode is continuous with the timecode of the

last frame of the last clip recorded on the disc.

To record continuous timecode

Before you start recording, set TCG on page P2 of the

function menu to "INT" and set TC MODE to "REGEN".

Then write clip files to this unit from a connected computer

or other device.

Table of Contents