Download  Print this page

Sony PDW-70MD Instructions For Use Manual Page 34

Professional disc recorder.
Hide thumbs


Full salvage: Clips are reconstructed on the basis of
markers recorded on the disc. Nonvolatile memory
cannot be used, so processing takes longer than for a
quick salvage (about 30 seconds, although it depends
on the state of the disc).
You are prompted to execute a full salvage whenever
you insert a disc that was removed manually from a
powered off device after interruption of recording by
power off.
Note that no recorded clip contents are lost when the on/
standby switch on the front panel is set to standby during
recording, because the unit does not enter standby mode
until after the end of recording processing.
• Even after recording finishes, do not set the POWER
switch on the rear panel to off until the ACCESS
indicator has gone out.
• These functions salvage as much recorded material as
possible after an unforeseen accident, but 100%
restoration cannot be guaranteed.
• Even when these functions are used, it is not possible to
recover data from immediately before the interruption of
recording. The amount of data lost is as follows.
Quick salvage: From 2 to 4 seconds of data before the
interruption of recording.
Full salvage: From 4 to 6 seconds of data before the
interruption of recording.
• You are prompted to execute a full salvage every time
you insert a disc that has not been salvaged, or power the
unit on with such as disc loaded.
• No recording is possible on discs containing clips that
have not been salvaged, although it is possible to play
back the normally recorded sections. Recording
becomes possible if you perform a quick format, but this
erases all of the original recorded content.
To restore clips with a full salvage
Insert the disc on which recording did not end
The message "Salvage ?" appears on the display.
To cancel the clip salvage
Press the RESET button.
• The message "EJECT?" appears when "REC INH"
is displayed in the operation modes section of the
display. If the disc is write protected, eject the disc,
set the Write Inhibit tab to enable recording, and
then insert the disc again. If REC INH on page P1 of
the function menu is set to "ON", set it to "OFF" (see
page 66).
Handling Discs
• This operation cannot be cancelled once it begins.
Press the SET button.
Processing begins and the message "Executing."
When processing finishes, a message appears to
display the results.
If the message reads "Incomplete!", the clips that
failed were lost.


Table of Contents

   Related Manuals for Sony PDW-70MD

Comments to this Manuals

Symbols: 0
Latest comments: