Honda Super Cub 2019 Manual page 117

20180726215216_32K0GC000_eng_BOOK Page 117 Thursday, July 26 2018 21:57:26 JST
Tyre Puncture Removing Wheels
u
Rear axle
shaft
Drive chain adjusting nut
Installation
To install the rear wheel, reverse the
1.
removal procedure.
Install the side collars into the left and
right side wheel hub.
Tighten the rear axle nut.
2.
Torque: 59 N·m (6.0 kgf·m, 44 lbf·ft)
114
3.
Adjusting plate
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
4.
Drive chain
lock nut
5.
6.
Drive chain
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure a
fastener. Always replace a used cotter pin
with a new one.
Tighten the brake stopper arm nut.
Adjust the rear brake pedal freeplay.
Adjust the drive chain slack.
After installing the wheel, apply the brake
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
P. 85
2
P. 91
2