Table Of Lubricants - Lenze g500 Series Mounting Instructions

7 Maintenance
Maintenance operations

Table of lubricants

7.3.2 Table of lubricants
Lenze recommends
If you carry out an oil change, use the same type of oil as specified on the nameplate. The
oil changing intervals are reference values for normal ambient conditions and a
maximum oil temperature of 70 °C. Difficult operating conditions (e.g. high
temperatures, aggressive ambient media) require shorter intervals.
Lubricant Ambient
temperature
CLP 220 0 °C ... + 40 °C
CLP 460 0 °C ... + 40 °C
CLP HC 220 −30 °C ... + 40 °C
CLP HC 320 −20 °C ... + 50 °C
CLP HC 220 −20 °C ... + 40 °C
USDA H1
CLP PG 460 −20 °C ... + 40 °C
USDA H1
Tab. 10 Overview of lubricant types
Lubricants with a USDA H1 approval are approved for the use in the food industry.
)
Note!
In case of ambient temperatures < −20°C or > +40°C, please contact
Lenze!
Observe increased starting torques at low temperatures!
58
the use of the
Specification Changing intervals at 70°C
For the first
time after
Mineral oil with 16000 h
EP additives
Mineral oil with 16000 h
EP additives
Synthetic oil 25000 h
with a
poly−alpha−olefin
basis
Synthetic oil 25000 h
with a
poly−alpha−olefin
basis
Synthetic oil 16000 h
with a
poly−alpha−olefin
basis
H1 approval
Synthetic oil 16000 h
with a polyglycol
basis
H1 approval
following lubricants.
Not later than Fuchs
after
3 years Renolin
CLP220 / CLP
Plus 220
3 years Renolin
CLP460 / CLP
Plus 460
4 years Renolin Unisyn
CLP220 / XT 220
4 years Renolin Unisyn
CLP320 / XT 320
3 years Cassida Fluid
GL 220
3 years Cassida Fluid
WG 460
Lubricant manufacturer
Klüber Shell
Klüber oil Omala S2 G220
GEM 1−220 N Omala S2 GXV
220
Klüberoil Omala S2 G460
GEM 1−460 N Omala S2 GXV
460
Klübersynth Omala S4 GXV
GEM 4−220 N 220
Klübersynth Omala S4 GXV
GEM 4−320 N 320
Klüberoil −−−−−
4 UH1−220 N
Klüberoil −−−−−
UH1 6−460
Lenze ¯ MA 12.0014 ¯ 5.1